2.8 2.9 3.2 3.6 VR6

Part number 6B5530H-STD
ACL Race series connecting rod bearings
Audi / VW - 2.8 2.9 3.2 3.6 VR6 R32 R36 (BUB, BHK, AES, AUE, ABV, AAA, AMY)

Part number 6B5530HX-STD (+0.001" extra clearance)
ACL Race Series connecting rod bearings
Audi / VW - 2.8 2.9 3.2 3.6 VR6 R32 R36 (BUB, BHK, AES, AUE, ABV, AAA, AMY)

Part number 2T5532-STD
ACL thrust washers kit
VAG - 2.8 2.9 3.2 3.6 VR6 R32 R36

Part number 7M5532H-STD
ACL Race Series main bearings
Audi / VW - 2.8 2.9 3.2 3.6 VR6 R32 R36 (BUB, BHK, AES, AUE, ABV, AAA, AMY)

Part number 7M5532HX-STD (+0.001" extra clearance)
ACL Race Series main bearings
Audi / VW - 2.8 2.9 3.2 3.6 VR6 R32 R36 (BUB, BHK, AES, AUE, ABV, AAA, AMY)

Part number 7M5532H-0.25
ACL Race Series main bearings
Audi / VW - 2.8 2.9 3.2 3.6 VR6 R32 R36 (BUB, BHK, AES, AUE, ABV, AAA, AMY)

Part number 50009880.
Kolbenschmidt plain bearing measuring tape / plastic gauge kit (10 pcs.).
Measuring strips for the determination of bearing clearance for plain bearings

1. Remove the bearing cap, wipe the journal and bearing shell clear of oil.
2. Place a piece of Flexigauge across the bearing at the crown (see Figure 1).
3. Install the bearing cap and using a Torque Wrench tighten the bolts to the correct tension.
4. DO NOT REVOLVE THE SHAFT OR BEARINGS.
5. Remove bearing cap. The Flexigauge will be adhering either to the bearing or shaft.
6. Compare the width of the flattened Flexigauge with the graduation of the envelope. The figure within the graduations indicates the clearance in thousandths of an inch of millimetres, depending on which side of the envelope is used. (See Figure 2).
7. Taper is indicated when Flexigauge is wider at one end than the other, the amount of taper being the difference between the readings. The widest part of the Flexigauge represents the area of least clearance. “Barrelling” of the shaft when the Flexigauge is wider in the centre of the bearing.