Citroen

Ford CR4440XP 2.0 connecting rod bearings

Peugeot / Citroen 1.3 1.4 1.6 King Racing connecting rod bearings CR4493XP-STD

XP	XP

C4493-PR	C4493-PR

Quantity

4

Crankshaft

44.991 / 44.976

Housing

48.654 / 48.671

Max Wall

1.821

Max Length

19.741

Engines Peugeot / Citroen 1.3 TU2.4, TU2J2 (SOHC 8V)
                       1.4 TU3A, TU3CP, TU3M, TU3S (SOHC 8V)
                   1.4 TU3.2, TU3J2/Z, TU3JP '88-> (SOHC 8V)
                     1.4 Liter XY6B, XY7, XY8 (SOHC 8V)
                     1.6 Liter TU5J2, TU5J4, TU5JP, TU5JP4 (SOHC/DOHC 8-16V)
                     1.6 Liter XU5J, XU5JP (SOHC 8V)

€50.00

Peugeot / Citroen 1.4 1.5 1.6 King Racing main bearings MB5729XP-STD

XP	XP

M5729/1PR	M5729/1PR

XP	XP

M5729/2PR	M5729/2PR

Quantity

2

3

Crankshaft

49.982 / 49.962

Housing

53.711 / 53.731

Max Wall

1.854

Max Length

17.399

Engines Peugeot / Citroen
1.4 8V (TU3.2, TU3J2/Z, TU3JP '88->)
1.4 8V (TU3JP '05-)
1.5 8V (TUD5)
1.6 8V (XU5J, XU5JP)
1.6 8V-16V (TU5J2, TU5J4, TU5JP, TU5JP4)

€85.00

Kolbenschmidt plain bearing measuring tape/plastic gauge 120000417001

Part number 50009880.
Kolbenschmidt plain bearing measuring tape / plastic gauge kit (10 pcs.).
Measuring strips for the determination of bearing clearance for plain bearings

€18.00

Permatex Ultra Slick assembly lubricant for engine bearings 118ml (12 pcs.)

€215.00

ACL plain bearing measuring tape/flexigauge AR-1 (Red)

1. Remove the bearing cap, wipe the journal and bearing shell clear of oil.
2. Place a piece of Flexigauge across the bearing at the crown (see Figure 1).
3. Install the bearing cap and using a Torque Wrench tighten the bolts to the correct tension.
4. DO NOT REVOLVE THE SHAFT OR BEARINGS.
5. Remove bearing cap. The Flexigauge will be adhering either to the bearing or shaft.
6. Compare the width of the flattened Flexigauge with the graduation of the envelope. The figure within the graduations indicates the clearance in thousandths of an inch of millimetres, depending on which side of the envelope is used. (See Figure 2).
7. Taper is indicated when Flexigauge is wider at one end than the other, the amount of taper being the difference between the readings. The widest part of the Flexigauge represents the area of least clearance. “Barrelling” of the shaft when the Flexigauge is wider in the centre of the bearing.

€16.00