Spauskite čia norėdami atidaryti seną svetainės versiją
Visos kategorijos
Parts by Car
Parts by Car
Dalys pagal:

Audi RS4 2.7 Biturbo

Audi RS4 V6 2.7 Biturbo FCP X-profilio kaltiniai švaistikliai 154mm
Detali informacija

Gamintojas: FCP Engineering
Modelis: FCPRXA15456821
Profilis: X (Su tepimo kanalu iš alkūninio veleno į stūmoklio pirštą)
Ilgis tarp centrų: 154mm
Didžiosios skylės diametras: 56.8mm
Piršto diametras: 21mm
Kiekis: 6 vnt., 12 vnt. ARP2000 varžtų
Pagaminta iš: kaltinio plieno 4340 EN24er
Rekomenduojama maksimali variklio galia: 1200AG (6 cilindrams)
Maksimalūs variklio sūkiai: 9000aps./min.
Audi RS4 - 2.7 V6 Biturbo
749,00 EUR
Kolbenschmidt indėklų tarpelio matavimo juostelių rinkinys 50009880

Prekės kodas 50009880.
Kolbenschmidt plastikinių matavimo juostelių rinkinys (10 vnt.).
Šios matavimo juostelės yra skirtos nustatyti indėklų tarpelį.

15,00 EUR
ACL indėklų tarpelio matavimo juostelių rinkinys AG-1 (Žalios sp.)
  1. Remove the bearing cap, wipe the journal and bearing shell clear of oil.
  2. Place a piece of Flexigauge across the bearing at the crown (see Figure 1).
  3. Install the bearing cap and using a Torque Wrench tighten the bolts to the correct tension.
  4. Remove bearing cap. The Flexigauge will be adhering either to the bearing or shaft.
  5. Compare the width of the flattened Flexigauge with the graduation of the envelope. The figure within the graduations indicates the clearance in thousandths of an inch of millimetres, depending on which side of the envelope is used. (See Figure 2)
  6. Taper is indicated when Flexigauge is wider at one end than the other, the amount of taper being the difference between the readings. The widest part of the Flexigauge represents the area of least clearance. “Barrelling” of the shaft when the Flexigauge is wider in the centre of the bearing.

15,00 EUR
ARP varžtų tempimosi matavimo prietaisas 100-9942
This gauge has been developed to provide optimum accuracy in determining the correct pre-load in the installed rod bolt. The products main purpose is to obtain the proper torque load when installed in the engine, and monitoring the condition of the bolt while in use. This is particularly useful if an engine is internally monitored regularly.
279,00 EUR