Spauskite čia norėdami atidaryti seną svetainės versiją
Visos kategorijos
Parts by Car
Go
Parts by Car
Go
Dalys pagal:
Kategorija

S63B44

BMW M5 F10 V8 S63B44 FCP Kaltiniai švaistikliai 138.2mm
Product detailed specification

Manufacturer: FCP Engineering
Model: FCPRHBS63B44
Profile: H-beam
C to C: 138.2mm
Pin diameter: 22mm
Quantity: 8 pcs., 16 pcs. ARP2000 5/16" bolts
Made of: forged steel 4340 EN24er
Advertised horsepower rating: 1200HP (8 cylinder)
Advertised RPM rating: 9000RPM
BMW M5 F10 - 4.4 V8 (S63B44)
749,00 EUR
Kolbenschmidt indėklų tarpelio matavimo juostelių rinkinys 50009880

Prekės kodas 50009880.
Kolbenschmidt plastikinių matavimo juostelių rinkinys (10 vnt.).
Šios matavimo juostelės yra skirtos nustatyti indėklų tarpelį.

13,00 EUR
ACL indėklų tarpelio matavimo juostelių rinkinys AG-1 (Žalios sp.)
  1. Remove the bearing cap, wipe the journal and bearing shell clear of oil.
  2. Place a piece of Flexigauge across the bearing at the crown (see Figure 1).
  3. Install the bearing cap and using a Torque Wrench tighten the bolts to the correct tension.
    DO NOT REVOLVE THE SHAFT OR BEARINGS.
  4. Remove bearing cap. The Flexigauge will be adhering either to the bearing or shaft.
  5. Compare the width of the flattened Flexigauge with the graduation of the envelope. The figure within the graduations indicates the clearance in thousandths of an inch of millimetres, depending on which side of the envelope is used. (See Figure 2)
  6. Taper is indicated when Flexigauge is wider at one end than the other, the amount of taper being the difference between the readings. The widest part of the Flexigauge represents the area of least clearance. “Barrelling” of the shaft when the Flexigauge is wider in the centre of the bearing.


15,00 EUR
Permatex Ultra Slick surinkimo tepalas variklio indėklams 118ml

Prekės kodas 81950
Permatex Ultra Slick surinkimo lubrikantas variklio indėklams.
Talpa 118 ml.

12,00 EUR
ARP varžtų tempimosi matavimo prietaisas 100-9942
This gauge has been developed to provide optimum accuracy in determining the correct pre-load in the installed rod bolt. The products main purpose is to obtain the proper torque load when installed in the engine, and monitoring the condition of the bolt while in use. This is particularly useful if an engine is internally monitored regularly.
279,00 EUR